Filter serial cable

Open the device manager to check the port number if the driver is installed on the computer, the driver to be installed will be detected automatically, otherwise the 2 CPX driver will need to be installed. After confirming the error, click the ok button continuously. Go back to the Camera Control page. Skip to content. Related Products. Safety instructions and precautions 1. Safety instructions and precautions.

Safety instructions 1. Precautions: 1. Before installation, you need to prepare the tools needed to install the filter wheel: tweezers, medium cross screwdriver, clock screwdriver.

After the installation is complete, please use the software to control the color wheel rotation to see if the rotation is smooth and whether every position can come. Whether there is a serious card in the middle if there is a slight card in the middle, it will not affect the use, the color wheel will continue to rotate until it reaches the target. Do not push hard when installing the filter wheel. Failure to do so may result in bearing crushage and other malfunctions or damage. There is the 12V power in the 4PIN socket.

So it does not need any extra power supply. You can use the USB socket to connect with the computer. When using this method. The current drawing from USB cable will reduce to less than mA when motor rotating.

Reset button : After pressing, the filter wheel hardware is reset, the turntable returns to the initial position, the default hole 1 Filter wheel standard accessories 1. Take MDL as example. Then, connect the filter wheel and camera with 4pin wires in sequence except for the special trigger cable except QHY9 , connect the camera and computer with USB cable, and connect a 12V power supply to power the camera.

After the correct connection, the third generation filter wheel will automatically rotate two turns and then rest. First, we need to switch the control port button shown by the red arrow in the figure below to implement USB port control. Observation indicator red light indicates USB control mode. This will ensure that the software runs in an orderly manner.

As shown below:. Click on Advanced in the lower left corner. Select the connected filter wheel in the strip box. Click on Properties to determine the filter wheel properties. Make sure to select the port that matches the previous download driver, click ok to return to the Camera Control page. After returning to the Camera Control page, click the connect link in the top right corner. Finally, switch to the Expose page, click the Filter button in the lower left corner, select the options in the drop-down menu, select the option, the filter wheel rotates, and the operation is successful.

Close Topic. Product Order News. I even tried the CHG chipset adapter, the same issue occurs. Behavior is the same in all of them. Behavior is the same. After some time the wheel starts to turn and stops in the first filter It does this at startup without any command from RS apparently 3 - Using standalone app you have in the site I set in the first screen COM1 4 - Press Connect 5 - After some seconds 5 to 10 it seems connect as it shows disconnect button and shows buttons of seven filters enabled, but no message of connection is visible.

The lack of any error message of feedback in app make the debugging very difficult. If you have any suggestions I can test it here, ps: I am electronics engineer, then I have equipment here to check. Regards Virus-free. Regards, Terry From: Tommy Lim via groups. This cannot be undone. The Group moderators are responsible for maintaining their community and can address these issues. Report to Groups. This includes: harm to minors, violence or threats, harassment or privacy invasion, impersonation or misrepresentation, fraud or phishing.

Note: Your email address is included with the abuse report. Hi Tom,. If you want to mail us the wheel or just the PCB , we can try to determine what is causing the problem.